The training package includes:

1. The patented Freedom No-Pull Harness -- the ultimate training tool, featuring a martingale loop on the back of the harness, to tighten slightly around your dog's chest and discourage pulling - and a connection in the front that allows you to redirect attention back to you to make training your dog easy.

2. A Coordinating Training Leash which allows you to connect to the front and back of the harness simultaneously, or connect to the back of the harness and a collar at the same time, providing additional control over your dog.

3. Training instruction brochure.

4. Fitting instructions and Warranty Information.

The harness features a contrasting loop (which can be seen in the photos) to make it easier to put on and take off.

Sizing information: Use a soft tape measure (tailor's tape measure) or if you don't have one, you can use a piece of string or ribbon, mark the measurement around the chest and then measure the string from the end. Chest and neck measurements and weight recommendation:

• Martingale/Double Loop
• Side Release/Buckle
• Combo Collar

The set includes 4 colorful Paw Pods (assorted colors.) Each Pod measures 5" (13cm) in diameter. The Paw Pods are made from a firm yet flexible PVC material with an air-filled chamber. The Paw Pods are shipped inflated. Adjust the balance challenge by changing the amount of air inside each pod with a needle pump (not included.) You can also change the difficulty level by using the Paw Pods placed with the flat side down (less challenging) or the dome side down (more challenging.) The FitPAWS Paw Pods feature sensory bumps on top for neural stimulation and grip capability.

If your dog competes in conformation events, you’ll need this latest positive training tool to teach the art of stacking. Instruction insert included.

The FitPAWS Donut provides a moderate balance challenge. Its broad base offers more stability than a round ball. (For extra stability, we recommend purchasing the FitPAWS® Donut Holder.) You can also adjust the balance challenge by under-inflating so the ball is not as firm. It has textured bumps on one side and a smooth surface on the other side. It is approximately 12” high and easily inflates/adjusts with the included hand-held air pump.

Helpful inflation hint: The FitPAWS Donut is inflated by measuring to a desired height, not by air pressure (psi.) For best results, do not inflate over 13” high, measured when the Donut is sitting with the flat side on the ground. You can always use the Donut less inflated, if you wish. We have found most people use the Donut inflated to about 12” in height.

The FitPAWS Donut can be inflated with the included air pump or your own air compressor that has a cone-shaped attachment. On the side of the Donut, you will see a white plug that will need to be removed before the air will go in. The plug may instead be taped to the side of the Donut. If it is, remove and keep plug handy. Place the tip of the pump's cone shaped attachment in the hole of the Donut, inflate to desired height and replace the plug firmly to hold the air inside.